K1 Max Cable Chain Delete using Cable Tie

I have removed K1 Max Cable Chain and replaced it with 500mm x 7.4 (8mm) Cable Tie. I did not want to use a riser and keep it horizontal.
Cable Mount 5 Deg has upwards angle to help offset cable sag.
Need to cut off the triangle tip and lock off the cable tie so ends are square and max length available.
I used rear mount slot with 2 x 2mm Counter Sunk self taping screws, and front mount socket friction fit.
You can use slot or socket or mix and match for best combination that works for you. slot can be secure with screws or heat shrink and socket is friction fit.
Should also work for K1 but will need to cut cable tie to correct length.
Print with high temp filament