K2 Plus CFS Riser

K2 Plus CFS Riser (new)After some feedback, I have updated (added) some pegs that can go in the hexagonal holes to hold up the tempered glass panel or even be used as a rack for spare build plates. The tolerance is very tight, and therefore when you initially wiggle the pegs in, you may need to slide them in and out a few times so they can be shifted easier in the future.The riser itself requires (one) 1" x 4" furring strip board from Home Depot/Lowes and then (eight) #6 - 3/4" wood screws from any hardware store. Cut the board straight down the middle and the length of those newly cut strips at about 17" long and the rest is straightforward. You will also need to reverse the short 485 cable so the corner connection is plugged into the CFS instead of the buffer as originally shown in the printer setup manual.No supports are needed to print these in the orientation shown in the cover image