Thingiverse
Music
Go to Model
Kazoo holder
21
Downloads
15
Likes
0
Makes
This is a kazoo holder to be put into a usual harmonica neck holder.
I've printed it with my cheap wooden Geeetech Prusa printer.
Additional needed parts:
- harmonica neck holder
to combine top part and bottom part:
- 2 screws M3x20 DIN 912/ISO 4762
- 2 Nuts M3 DIN 934
to fix side parts:
- 2 Screws M3x16 DIN 912/ISO 4762 or similar
- 2 Washers 3,2 DIN 9021 or similar
and a little part of rubber mesh or rupper plate to be clued on the inner bottom face of the bottom part. With this rubber it is not necessary to tighten the screws to strong so that the kazoo may be damaged.
I've printed it with my cheap wooden Geeetech Prusa printer.
Additional needed parts:
- harmonica neck holder
to combine top part and bottom part:
- 2 screws M3x20 DIN 912/ISO 4762
- 2 Nuts M3 DIN 934
to fix side parts:
- 2 Screws M3x16 DIN 912/ISO 4762 or similar
- 2 Washers 3,2 DIN 9021 or similar
and a little part of rubber mesh or rupper plate to be clued on the inner bottom face of the bottom part. With this rubber it is not necessary to tighten the screws to strong so that the kazoo may be damaged.
Findusdwarf also publishes on
75 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
