Thingiverse
Keep Spool Aligned
von telmovmx
1
Downloads
1
Likes
0
Makes
The filament spool was always sliding sideways and even got tilted off the spool holder, so I've made this piece to keep the spool in place and aligned with the extruder of my printer!
NOTE: This piece is like a cap which fits the black tube that supports the filament spool (so it doesn't get centered with the filament spool), but in future update I will extended it to the full length of the black tube, making the piece not only a stabilizer but also centered with the filament spool.
NOTE: This piece is like a cap which fits the black tube that supports the filament spool (so it doesn't get centered with the filament spool), but in future update I will extended it to the full length of the black tube, making the piece not only a stabilizer but also centered with the filament spool.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
