Thingiverse
Key Hangar
von PyrexFlask
1
Downloads
1
Likes
0
Makes
Summary
I designed this minimalist hangar for Coats & EDC items, it's working really well, very useful and gets lots of positive comments!
I have been using it for a few months, printed in ABS using the Voron print settings:
0.2mm layer height, .4mm extrusion width, 40% infill, 4 perimeters, and 5 top/bottom layers.
It has pockets in the back for M4 nuts,I'm using Nyloc nuts to stop the dowels from loosening. There are 2x mounting holes for 4mm screws, the screw holes are discreet so some 3m VHB tape or similar could maybe be used.
The dowels are maybe overkill but they look very cool!
https://www.ebay.co.uk/itm/274521611680?hash=item3feac35da0:g:8K8AAOSwIB9feyeJ
I designed this minimalist hangar for Coats & EDC items, it's working really well, very useful and gets lots of positive comments!
I have been using it for a few months, printed in ABS using the Voron print settings:
0.2mm layer height, .4mm extrusion width, 40% infill, 4 perimeters, and 5 top/bottom layers.
It has pockets in the back for M4 nuts,I'm using Nyloc nuts to stop the dowels from loosening. There are 2x mounting holes for 4mm screws, the screw holes are discreet so some 3m VHB tape or similar could maybe be used.
The dowels are maybe overkill but they look very cool!
https://www.ebay.co.uk/itm/274521611680?hash=item3feac35da0:g:8K8AAOSwIB9feyeJ
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!