Thingiverse
Key hideout
door PA3DPrints
4
Downloads
6
Likes
0
Makes
This is a small case to hide your key under something magnetic.
To print this model, use 0.15 mm layers (initial and subsequent) for the bottom part (KEHI01-0002). Program a pause at height 3.3 mm to insert 10 mm diameter x 3 mm thick magnet. Secure with glue before continuing the print so that the magnets don't come flying at your hot end when it comes too close.
To print this model, use 0.15 mm layers (initial and subsequent) for the bottom part (KEHI01-0002). Program a pause at height 3.3 mm to insert 10 mm diameter x 3 mm thick magnet. Secure with glue before continuing the print so that the magnets don't come flying at your hot end when it comes too close.
PA3DPrints publiceert ook op
29 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
