Thingiverse
Key hideout
von PA3DPrints
4
Downloads
6
Likes
0
Makes
This is a small case to hide your key under something magnetic.
To print this model, use 0.15 mm layers (initial and subsequent) for the bottom part (KEHI01-0002). Program a pause at height 3.3 mm to insert 10 mm diameter x 3 mm thick magnet. Secure with glue before continuing the print so that the magnets don't come flying at your hot end when it comes too close.
To print this model, use 0.15 mm layers (initial and subsequent) for the bottom part (KEHI01-0002). Program a pause at height 3.3 mm to insert 10 mm diameter x 3 mm thick magnet. Secure with glue before continuing the print so that the magnets don't come flying at your hot end when it comes too close.
PA3DPrints veröffentlicht auch auf
29 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
