Thingiverse
Key holder
von roadrunner451
49
Downloads
49
Likes
1
Makes
Just a simple keyholder with a shelf.
The "add" is to get extra length in case you have big keychains :)
I printed this in PLA, 0.3 height and 20% infill
No supports needed.
The "add" is to get extra length in case you have big keychains :)
I printed this in PLA, 0.3 height and 20% infill
No supports needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
