Thingiverse
Key Holder
von Haggistech
10
Downloads
3
Likes
0
Makes
One of those fancy key holders that make your keyring like a swiss army knife :D
You will need the following
M3 Allen Cap Bolts (Length depends on how many keys your putting in it)
M3 Locking Nuts (I used locking nuts so it did not loosen)
You will need the following
M3 Allen Cap Bolts (Length depends on how many keys your putting in it)
M3 Locking Nuts (I used locking nuts so it did not loosen)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!