MakerWorld
Electronics
Zum Modell
Keyboard stand
24
Downloads
7
Likes
12
Makes
Keyboard stand I made this keyboard stand to make them as stable as possible. I added holes in the base to put non-slip feet if necessary (10mm diameter for 2mm depth).You can use it or not, it's not a problem.I use feet easily found on Amazon of 10x2.5 so that they stick out as little as possible. This is the link for the feet i used:https://www.amazon.it/dp/B06Y3NZDM1?ref=ppx_yo2ov_dt_b_fed_asin_title
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
