Thingiverse
Kill Switch Tether
5
Downloads
3
Likes
0
Makes
This is the magnet holder for a motorcycle kill switch. I lost mine at a competition and had to borrow a friend's for the day.
There are 2 designs. One you can print and super glue a magnet in. The other you'll need to pause the print at about 9mm (depending on your layer height), drop the magnet in, and continue printing. Might be a good idea to add a drop of super glue first. I didn't have an issue, but the magnet could jump to your print nozzle/head if you don't.
The magnets I used are 8mm in diameter and 3mm thick.
I printed mine in both ABS and TPU. I'd think almost any material would be fine.
There are 2 designs. One you can print and super glue a magnet in. The other you'll need to pause the print at about 9mm (depending on your layer height), drop the magnet in, and continue printing. Might be a good idea to add a drop of super glue first. I didn't have an issue, but the magnet could jump to your print nozzle/head if you don't.
The magnets I used are 8mm in diameter and 3mm thick.
I printed mine in both ABS and TPU. I'd think almost any material would be fine.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
