Thingiverse
Kitchen spongeholder
von Bouss31
10
Downloads
21
Likes
0
Makes
The original Kitchen Spongeholder by techam was almost the one I was wondering, expect that I have a smaller space between my wall and my sink.
I imported the V2 stl in SolidWorks and remove some matter to have just 15 mm of "low step" at the rear of the thing.
I imported the V2 stl in SolidWorks and remove some matter to have just 15 mm of "low step" at the rear of the thing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!