Thingiverse
Knife Sharpener Guide
von triffid_hunter
451
Downloads
292
Likes
0
Makes
Helps you put a consistent angle on your knife's cutting edge.
STLs are sized for a 50x200x25mm stone and 2mm blade width, see scad if your stone or blade is a different size.
STLs are sized for a 50x200x25mm stone and 2mm blade width, see scad if your stone or blade is a different size.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
