Thingiverse
Knife
von FRANKDTANK120
0
Downloads
1
Likes
0
Makes
Printing at 0.2mm layer height works perfectly. I would suggest one colour for all parts and use spray paint after. Tip of the blade sometimes pulls itself of the plate when printing due to the PLA shrinking when cooling, though it doesn't cause any problems. :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
