Thingiverse
Kolver Pluto Switch
por jsu3960862
0
Descargas
1
Likes
0
Makes
The Kolver Screwdrivers are awesome but in some cases, their design lacks a little bit. We had the switch break on a Kolver Pluto 10DN and so this model is an improved design. The original part was injection molded with two small plastic pegs coming out of it. This design eliminates the pegs for a 2mm steel pin that can be purchased below.
https://www.mcmaster.com/#93600a238/=1b95mjh
I understand this part may be very niche. These tools are commonly used on manufacturing assembly lines.
https://www.mcmaster.com/#93600a238/=1b95mjh
I understand this part may be very niche. These tools are commonly used on manufacturing assembly lines.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
