Thingiverse
Kossel Bed Leveling
por Yojimbojpr
66
Descargas
49
Likes
1
Makes
This is a bed leveling for Anycubic Kossel Plus, for a bed with 240mm diameter. I tried to minimized space for xploit all vertical interval.
Thread is M10x1, i tried M10x0.7 and is possible, but give some problems sometimes and doesnt present a clear advantage. And it is prepared for use DIN-7380 M4 screws.
There are two nut, lower is narrow for make more space and also have mark each 1/4 turn to have better leveling control, superior one is a little bit gross for better press
For a 240mm cristal bed Kossel you need to change reference points to; (-90,0,0), (45-78,0) and (45,78,0).
New version of base added, with less extrude length, 12mm are not necessary at all, I went down it to 8.
Thread is M10x1, i tried M10x0.7 and is possible, but give some problems sometimes and doesnt present a clear advantage. And it is prepared for use DIN-7380 M4 screws.
There are two nut, lower is narrow for make more space and also have mark each 1/4 turn to have better leveling control, superior one is a little bit gross for better press
For a 240mm cristal bed Kossel you need to change reference points to; (-90,0,0), (45-78,0) and (45,78,0).
New version of base added, with less extrude length, 12mm are not necessary at all, I went down it to 8.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
