Thingiverse
Kossel Effector Set
von JensG
11
Downloads
4
Likes
0
Makes
The fan_duct_V3 is adjusted based on the model of AndrewBCN. Thanks Andrew.
Retractable and Hotend Fan Adapter are designed for a bolt circle of 14.5mm.
The insets on the back of the pin socket are for 2.54mm 2x5 pin headers. I use one for permanent 12V (Hotend fan) and one for cooling as shown in the pictures.
To assemble the pin lock, 2 screws M2x10 and a M3x8 are required. The spring size is 5x2mm.
The switch bridge is required so that the endstop can be slightly displaced laterally. A M3x10 screw is needed and this must not be completely tightened.
Retractable and Hotend Fan Adapter are designed for a bolt circle of 14.5mm.
The insets on the back of the pin socket are for 2.54mm 2x5 pin headers. I use one for permanent 12V (Hotend fan) and one for cooling as shown in the pictures.
To assemble the pin lock, 2 screws M2x10 and a M3x8 are required. The spring size is 5x2mm.
The switch bridge is required so that the endstop can be slightly displaced laterally. A M3x10 screw is needed and this must not be completely tightened.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!