Thingiverse
Kroot War Sphere
von Tezca
359
Downloads
191
Likes
2
Makes
EDIT: increased diametre of the pegs that connect the rings to one another and the cap piece, and the size of the guide pegs from the innersphere connector to the ring 2 cross beams. tl:dr made it better
No idea how this prints in a single piece, or the supports involved, as it's really meant to be printed in pieces.
The rings and cap are meant to be put together with a bit of luck and a keen eye, I provided no guides. ring 1 (big one) on the inside, ring 2 next, then cap. Don't overthink where they attach.
Once those are assembled, the inner ball attaches to the Ring_2 cross-support piece, with guide pegs to line up a better fit found on the end of the innerball connector arms.
Print doubles of the rings and cap, of course.
No idea how this prints in a single piece, or the supports involved, as it's really meant to be printed in pieces.
The rings and cap are meant to be put together with a bit of luck and a keen eye, I provided no guides. ring 1 (big one) on the inside, ring 2 next, then cap. Don't overthink where they attach.
Once those are assembled, the inner ball attaches to the Ring_2 cross-support piece, with guide pegs to line up a better fit found on the end of the innerball connector arms.
Print doubles of the rings and cap, of course.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
