Kunai MIDI Controller

This is a MIDI controller which can almost fully be made from scratch!

The required materials for making this MIDI controller are as follows:

You will need:
- 16 30mm SANWA arcade pushbuttons
( or anything with the same pinout, NOTE: CHEAP ARCADE BUTTONS DO NOT WORK, THEY HAVE DIFFERENT PINOUTS THAN QUALITY ARCADE BUTTONS SUCH AS SANWA or HORI FOR EXAMPLE )

- 32 female fuse clip connectors to connect the buttons to the PCB ( https://www.digikey.ca/product-detail/en/keystone-electronics/3557/36-3557-ND/2092485 )

- Teensy micro controller

- Blank PCB

- PCB Transfer paper


The included PDF should be printed at 100% onto transfer paper for making the PCB , there is 2 images of the PCB as to not waste transfer paper

IF YOU WISH TO NOT USE A PCB, ALL THE PUSH BUTTONS CAN BE CONNECTED TO GROUND AND AN INDIVIDUAL PIN ( Though the included .ino file will not necessarily map correctly if you don't use the PCB )