Thingiverse
Kylo Ren Conversion
por weaver7237
1
Descargas
0
Likes
0
Makes
This is all the parts needed to convert a Disny Legacy Kylo Ren lightsaber to aftermarket soundboard, i.e. Proffie, GHv3, etc.
Sized to fit in a Halot R6 resin printer, but shoud fit almost all resin printers. Used ABS Like resin.
Remove all internals from saber hilt and replace with these. I mounted a single LED strip (2 pixels) for the chamber at the bottom.
For buttons, I cut out the existing buttons and left the holes, installed the button panel and mounted switches underneath.
I used standard battery connection tabs for 18650 battery in the battery bay. All wiring from upper to soundboard area runs under the battery bay.
Sized to fit in a Halot R6 resin printer, but shoud fit almost all resin printers. Used ABS Like resin.
Remove all internals from saber hilt and replace with these. I mounted a single LED strip (2 pixels) for the chamber at the bottom.
For buttons, I cut out the existing buttons and left the holes, installed the button panel and mounted switches underneath.
I used standard battery connection tabs for 18650 battery in the battery bay. All wiring from upper to soundboard area runs under the battery bay.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
