Kyria Ergo Tented Case

This is a remix of [this case](https://www.thingiverse.com/thing:4378710). It is exactly the same but I added the holes on the inside edges to tent the case. Please look at the source case to see what other hardware is required.

The holes fit an M5 screw, length depends on the desired angle for tenting. In the pictures I'm using an M5x60mm in each.

To print the right side, just mirror the object in the slicer. This is easy to do in Cura, I'm not sure about other slicers.

There are matching wrist rests here:
https://www.thingiverse.com/thing:4858246