LABO VR Headstrap Mounts

Nintendo LABO VR Headset mounting clips. The side mounts are intended to snap into the original grommet locations on the side of the VR lenses, and the top mount is intended to install with a small cut in the cardboard.


Parts Required:
-1x Grommet

-2x Raised Strap Clip (Supports) OR Strap Clip

-1x Large Strap Clip OR Large Strap Clip (Supports)



The "Raised Strap Clip (Supports)" will snap right into the existing headset grommets, but require a large amount of support under the part. The "Strap Clip" does not need supports, but will require cuts on the side of the headset to be installed.

The "Large Strap Clip" does not require supports when printing. It uses a sacrificial bridge on the large overhang, so it will require a small amount of cleanup. The "Large Strap Clip (Supports)" does not include the sacrificial bridge and will need supports for printing.

I would recommend using the 2x "Raised Strap Clip (Supports)" and the 1x "Large Strap Cli