Thingiverse
Lack Table Corner mounts
von Daon
1
Downloads
1
Likes
0
Makes
The Lack Table Corner mounts I designed in blender are made with transparent petg 100% infill on my Creality k2 plus.
Only purpose of these 4 corner mounts is to keep it from sliding off the board with the 4 industrial casters.
I included additional screw holes if incase I wanted to mount it permanently to the base board.
Hardware I used was #8 x 3/4in wood screws and #8 Washers from HomeDepot
If interested the casters I used were "2 Inch Caster Wheels, Casters Set of 4" on Amazon
Only purpose of these 4 corner mounts is to keep it from sliding off the board with the 4 industrial casters.
I included additional screw holes if incase I wanted to mount it permanently to the base board.
Hardware I used was #8 x 3/4in wood screws and #8 Washers from HomeDepot
If interested the casters I used were "2 Inch Caster Wheels, Casters Set of 4" on Amazon
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
