Thingiverse
Lamp support bracket
von Daveysawyer
1
Downloads
0
Likes
0
Makes
This is the first thing that I've done from scratch for the 3D printer. I've only just got a printer, so still finding my feet with it all.
This item is a part from a 6ft FL lamp, and these clips break quite a bit, so I drew this out with the intention of printing new clips on demand. The new clip is modded from the original, as it's made for the 3D printer and not injection moulding.
Used SketchUp for the modelling and then exported as an .obj file and did the settings in ReplicatorG.
This item is a part from a 6ft FL lamp, and these clips break quite a bit, so I drew this out with the intention of printing new clips on demand. The new clip is modded from the original, as it's made for the 3D printer and not injection moulding.
Used SketchUp for the modelling and then exported as an .obj file and did the settings in ReplicatorG.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!