Thingiverse
Lantern "Candle" Insert
by Ichigoli
0
Downloads
1
Likes
0
Makes
The Little Lantern full size file made a beautiful print, but I needed a way to secure an LED candle in the opening that could be easily removed or replaced. This insert is sized to fit any LED candle that would fit a standard candle holder. [DO NOT USE A REAL CANDLE IN THIS YOU GUYS]
It is designed to grip into the glued two halves of the full sized print but may need a little tape to add grip and hold the candle in place. The notch on the flat side will help grip to pop it out in case your grip tension is higher than a light jostle will dislodge.
If you resize the lantern, size the insert at the same scale, and the collar can still help hold lights in place.
It is designed to grip into the glued two halves of the full sized print but may need a little tape to add grip and hold the candle in place. The notch on the flat side will help grip to pop it out in case your grip tension is higher than a light jostle will dislodge.
If you resize the lantern, size the insert at the same scale, and the collar can still help hold lights in place.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
