Lantern Fish Light

I created the fish lantern as a night light for my daughter and thought that others my also want to create the same light for themselves or children.

The Fin, Eyes, Mouth and Tentacle will need to be located and glued in place, I used super glue and a hot glue gun.

The tentacle is printed is 2 halves and will also need to be glues together.

The bottom nut and the tentacle bottom are threaded to allow access after you have finished your build do not glue these parts.

The lamp has been design that it can be used as a:

1. A night light with the 1 or 2 neo-pixel rings thus you would print parts 12 and 13 to mount the led ring and arduino nano

2. A night light with your own custom leds or led bulb, each fin also has a 8 mm hole to mount a small LED if you wanted, thus you would print part 14 instead and or customize your own disk to mount your setup. (89.4 mm x 3 mm disk with a 20 mm center hole)

3. As a money box, instead print parts 4 - b and 15, this is a coin slot