Slicer Discord
Large Spiral Easter Egg – 3D-printbaar model van Thingiverse Thingiverse

Large Spiral Easter Egg

door dazus
44 Downloads
33 Likes
0 Makes
Model downloaden
**KEEP MAGNETS AWAY FROM SMALL CHILDREN. Magnets can come loose. If swallowed, magnets can be FATAL.**

####Not To Be Sold
**I'm sharing my files so that you can make them for yourselves or give them away as gifts. I hope you enjoy them. I do not authorize sale of my work by anyone. Please don't ask me.**

####About The Design
Another fun Easter Egg design. You can change the pattern of the egg by rotating the two halves of the egg relative to one another. Check out the photos see to it.

This egg is 25% larger than the others I've published – about 13 cm (5 inches) high. Why? I experimented with different combinations of magnets and it became clear that I needed at least one 3x1 mm magnet in each arm. Smaller magnets didn't have enough hold and were difficult to install. In order to fit a 3x1 magnet in each arm of this design, I needed to enlarge the egg quite a bit.You'll need 16 magnets in total.

**Quick Tip:** The easiest way I've found to install the magnets is to get
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
geen supports
Zonder supports Eendelig Hardware nodig
Supports 0/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie