Laser Bed Leveler

I wanted a very simple and easy way to level my laser bed for my laser engraver. This works for me. This could be used for a variety of various leveling purposes. While it is not designed to be incredibly heavy duty, if you were to fill in the button head area where the screw is with epoxy, hot glue, or baking soda and super glue, and then sand it flat, I bet this would actually hold a decent amount of weight. Any of those could potentially produce enough heat to melt the plastic so use caution.

Uses 1/4-20 by 0.5in button head screws and nuts from Home Depot. The screw just screws into place, some glue may or may not be necessary depending on your application. The nut is press fit.

Making it out of TPU or adding thin neoprene to the top and bottom may help if you want to keep it from sliding around.