Laser Quickmount
von achmed20
17
Downloads
14
Likes
0
Makes
Since the original laser mount didnt work with mine, i made this one. this is a pretty fast sketch and i wanted something where i didnt need supports to print it, which is why its offets so so much.
On a sidenote, this is a 3 Port laser (12v, pwm, gnd) but the PWM signal cant take more then 5v. if you need a 5V signal, check the pins where the BLtouch usualy goes (D11). on my CR-10S I have a pin left (D12) which is 5V and where i grab my signal.
The actual quickchange mount comes from ProperPrinting (https://www.thingiverse.com/thing:3369444) and is for the CR-10 and Ender 3 series. but you can find other mounts for other printers under remixes.
Please be aware that i am using a D-SUB 9 socket contrary to ProperPrinting who uses a D-SUB 15 (like) one
On a sidenote, this is a 3 Port laser (12v, pwm, gnd) but the PWM signal cant take more then 5v. if you need a 5V signal, check the pins where the BLtouch usualy goes (D11). on my CR-10S I have a pin left (D12) which is 5V and where i grab my signal.
The actual quickchange mount comes from ProperPrinting (https://www.thingiverse.com/thing:3369444) and is for the CR-10 and Ender 3 series. but you can find other mounts for other printers under remixes.
Please be aware that i am using a D-SUB 9 socket contrary to ProperPrinting who uses a D-SUB 15 (like) one
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
