Thingiverse
LaserBeamTarget
door Takeaway3DTech
29
Downloads
20
Likes
0
Makes
Laser beam Target to fit a Universal M300 laser to align the laser beam.
The Laser I have is an old > 10 years used laser cutter The problem seen was push fit bearing holes were not straight so bearings did not fit vertical to the board surface see pic of single bearing.
I noticed that the Lense assembly had a secondary counter bore around the laser hole made a target to fit the counter bore to alow laser alignment using the red spot laser / Lid open mode.
Push fit bearings now sit parallel after laser adjustment using the target
The Laser I have is an old > 10 years used laser cutter The problem seen was push fit bearing holes were not straight so bearings did not fit vertical to the board surface see pic of single bearing.
I noticed that the Lense assembly had a secondary counter bore around the laser hole made a target to fit the counter bore to alow laser alignment using the red spot laser / Lid open mode.
Push fit bearings now sit parallel after laser adjustment using the target
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
