Thingiverse
Leadfoot (Pb') case for Raspberry Pi Zero W
4
Descargas
6
Likes
0
Makes
A Leadfoot case has "ballast" (sand) in the base to make it a little heavier. Sits better on the desk when you connect cables etc.
The case in the picture, I printed in PETG. Fits Raspberry Pi Zero W. The classic Zero should work as well (though there is a hole for the camera connector).
There's a hole in the sidewall where the sand goes. Then use the plug or just fill the hole with glue.
The case in the picture, I printed in PETG. Fits Raspberry Pi Zero W. The classic Zero should work as well (though there is a hole for the camera connector).
There's a hole in the sidewall where the sand goes. Then use the plug or just fill the hole with glue.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!