Thingiverse
Leadfoot (Pb') case for Raspberry Pi Zero W
4
Downloads
6
Likes
0
Makes
A Leadfoot case has "ballast" (sand) in the base to make it a little heavier. Sits better on the desk when you connect cables etc.
The case in the picture, I printed in PETG. Fits Raspberry Pi Zero W. The classic Zero should work as well (though there is a hole for the camera connector).
There's a hole in the sidewall where the sand goes. Then use the plug or just fill the hole with glue.
The case in the picture, I printed in PETG. Fits Raspberry Pi Zero W. The classic Zero should work as well (though there is a hole for the camera connector).
There's a hole in the sidewall where the sand goes. Then use the plug or just fill the hole with glue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!