Thingiverse
Leaf Flowerpot
von guesty_1088
2
Downloads
2
Likes
0
Makes
A very simple flowerpot with a leaf design.
This was my first ever 3D design. I pulled it together in 10 minutes, out of excitement of testing my new printer. A few moderations have been made since (including the hole in the bottom). Supports are recommended.
Enjoy! :)
Note: If this design will be placed in a warm, sunny place, take care to choose materials that will stand up to high temperatures. Not recommended for PLA.
This was my first ever 3D design. I pulled it together in 10 minutes, out of excitement of testing my new printer. A few moderations have been made since (including the hole in the bottom). Supports are recommended.
Enjoy! :)
Note: If this design will be placed in a warm, sunny place, take care to choose materials that will stand up to high temperatures. Not recommended for PLA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
