leather stitching clamp

When slicing make sure model is on its side(should be already) so the print lines are vertical in relation to real life use. This will give the model extra strength in real life use. I would suggest that the model is made as a 4 inch long clamp so in Cura set the height to 101.6 mm to get the 4 in. This post will get an update once I have a photo of the completed project. You will need to purchase or have some wood that you can use for this project.

With stated settings the print should be around 9 hours 59 minutes

(update): print will need to be scaled and rotated, make sure to scale z to 101.6(uniform scaling) after rotated onto the side.