Thingiverse
LED array mount for 8x8 matrix
von shearn
10
Downloads
8
Likes
0
Makes
This is a holder for the 8x8 LED matrix found at:
http://www.sparkfun.com/products/682
It is designed with a crossbar as a standoff for the pins coming out on the backside. However, it is not absolutely necessary if printed at just the right size as the LED array will be snug in the holder.
I made this in OpenSCAD, but lost the file, which I may include later if I get around to rewriting it.
http://www.sparkfun.com/products/682
It is designed with a crossbar as a standoff for the pins coming out on the backside. However, it is not absolutely necessary if printed at just the right size as the LED array will be snug in the holder.
I made this in OpenSCAD, but lost the file, which I may include later if I get around to rewriting it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
