Thingiverse
LED Base
por JobSmolders
34
Descargas
42
Likes
1
Makes
Simple LED base.
By turning the orange ring it is possible to open and close the “light slots”.
In this way you can experiment with the light escaping, which creates illusive light effects.
Also it helps the LED’s cool better if there is a lampshade with bottom on top of it.
The LED’s are glued on an Aluminum ring I had lying around. At first I wanted to make 3 round aluminum plates of 20 mm but I was lazy :-)
Printed in ABS silver and orange 0.2mm resolution.
By turning the orange ring it is possible to open and close the “light slots”.
In this way you can experiment with the light escaping, which creates illusive light effects.
Also it helps the LED’s cool better if there is a lampshade with bottom on top of it.
The LED’s are glued on an Aluminum ring I had lying around. At first I wanted to make 3 round aluminum plates of 20 mm but I was lazy :-)
Printed in ABS silver and orange 0.2mm resolution.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
