Thingiverse
LED Clock
von Clarcy
26
Downloads
22
Likes
0
Makes
This LED clock is based on the O-Clock by [Hans Anderson](https://www.youtube.com/watch?v=ZZIBVo69F24).
This one was newly created, is only 25cm small and fits on a 30cm print bed.
The source code was modified for the ESP32. If my WiFi is switched on, it gets the time once a day.
The light sensor has been removed. I set fixed times for the brightness. The minute display lights up slightly darker than the five minute display. But are relatively easy to see. From 10 p.m., the LEDs light up at the lowest level and only the 15 minutes are displayed. I have the clock by my bed. When i wake up, i can understand the displayed time.
Printing time round 10 hours at PET 60mm/s.
Requires:
11 pices 2.5 x 8mm screws for the lid.
1 x 5V PSU (Phone supply or similar and a micro USB cable(white))
1 x 144 LED WS2812B LED Strip
This one was newly created, is only 25cm small and fits on a 30cm print bed.
The source code was modified for the ESP32. If my WiFi is switched on, it gets the time once a day.
The light sensor has been removed. I set fixed times for the brightness. The minute display lights up slightly darker than the five minute display. But are relatively easy to see. From 10 p.m., the LEDs light up at the lowest level and only the 15 minutes are displayed. I have the clock by my bed. When i wake up, i can understand the displayed time.
Printing time round 10 hours at PET 60mm/s.
Requires:
11 pices 2.5 x 8mm screws for the lid.
1 x 5V PSU (Phone supply or similar and a micro USB cable(white))
1 x 144 LED WS2812B LED Strip
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
