LED Cover Insert (parametric)

Parametric LED Cover Lens for electronics projects. Use this to allow light to pass through your designs from LEDs inside project boxes. Installation InstructionsPrint in transparent filament, insert into the hole and then firmly press filament in the back, clip the remaining filament off to secure it in place. Parametric design instructionsHow toClick on the Customize button, then change the variables on the left until you are satisfied with the design seen in the cross section. Then when you download the design, the download will contain a normal geometry (no cross section of measurements).DiameterYou can make this cover from holes of 4mm up to 5mm diameter, thicker is theoretically possible but the design does not allow it because the inserted filament will have less influence on the design, it might not hold.Panel thicknessYou can enter a panel thickness of .5mm to 8mm but I recommend you stay away from extremes. A thickness of 1.5mm to 5mm should be okay. Anything above 2mm will h