LED Crystals

This is my take on building a LED wall installation.What you need:your desired number of WS2812B (5V) LED chaina capable LED controller (my advice is a Node MCU with WLED flashed)M3 screws and nutssome translucid PLAHow to print:The single crystal should be printed in vase modethe multiple crystals need to be printed without infill, 1 or two outer layers and with a print blocker at the place where the LED attaches from belowuse a translucid material for best effectThe base does not need support, just print as it isif you have a multi material printer you can also print the crystal and the base in one part so you dont need to glue them later, but at the cost of some support for the baseHow to assemble:Print your desired pieces bases and screw them together with screws and nutsattach the LEDsadd glue to the top of the basesglue the crystals onto the basein that order you make sure the crystals are alligned wellThe filaments i used:Filamentums Crystal Clear PLA in Icelandic BlueAnycubic B