LED Diffuser Channel - Muzata

This is a model of the Muzata LED Diffuser Channels transformed into a 3D model. The 6-pack of 3.3 foot channels that came with the original product were great, but the space I had left to fill was well below the amount of channel size I had and needed, and I was not keen on cutting aluminum in my house. This is measured the same as the actual product, then I cut down the plastic diffuser cover from the original product to fit the size I needed. The model shown is printed at 15% cubic infill, and with a Generic Grey PLA that I had available.The LED lights inside sometimes unstick, which might be due to the unironed surface I printed, so if you enable printing for the surface the LEDs should ahere to, that likely will work. Also, since the channel is a long thin strip of plastic, I would suggest printing with a brim or mouse ears to prevent it from lifting off of the bed. Here is the product page if you want to know which diffuser I based the design from:Muzata 6-pack