Slicer Discord
LED Diffuser - Corner, dual – 3D-Druckmodell von Thingiverse Thingiverse

LED Diffuser - Corner, dual

von Dellsan
13 Downloads
9 Likes
0 Makes
Zum Modell
For diffusing LED strip light that you can get cheaply from Amazon, but then realize you need diffusing. However, the LEDs are 55mm/2.2 inches apart and it'll still look like bright and dark spots if you just try to diffuse them. In that case, use this to diffuse them even more, but using 2 LED strips that are far apart to diffuse the light a lot more smoothly. Offset the 2 LED strips so they'll create the illusion of a denser LED strip.

I used dual-sided tape to put the channel in the corner first. The diffusers pop right in afterwards.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen