Thingiverse
LED Diffuser Lens for Panel Mounting
por reactron
15
Descargas
18
Likes
1
Makes
LED bezel will mount into a ~12mm hole. Diffuser is to be printed using a translucent plastic. LED is either press-fit or glued in place.
Update: added second versions to provide a bit more tolerance (slop). Try printing one of each and see which set works best for you.
Pro Tip - if you find that the fit between the 2 parts is too tight, just increase the X and Y size of the nut in your slicer to be slightly larger ( somewhere around 106 percent should do the trick ).
Update: added second versions to provide a bit more tolerance (slop). Try printing one of each and see which set works best for you.
Pro Tip - if you find that the fit between the 2 parts is too tight, just increase the X and Y size of the nut in your slicer to be slightly larger ( somewhere around 106 percent should do the trick ).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
