Thingiverse
Led Light 3D Printer
von iAlbo
31
Downloads
25
Likes
0
Makes
Hello my friend, this is my last project.
Often we would like to see how our printing is going but due to the fan and the hotend we can not see well, so we use phone light and try to see the printing.
This time is over!
Now, with my project, you can observe your printing easily.
As always my project is full plug&play and exploit original screws to fit.
This upgrade use external 12v to not stress the 3dprinter's motherboard, you can swith on and off the light with a switch.
Into the download file I prepared a complete guide step by step and a list of what to buy (very very cheap things).
Rigid temperature test done, no more than 35°C into the led case, you can use safely PLA, PETG is however suggested.
Upgrade you 3d print now!
Often we would like to see how our printing is going but due to the fan and the hotend we can not see well, so we use phone light and try to see the printing.
This time is over!
Now, with my project, you can observe your printing easily.
As always my project is full plug&play and exploit original screws to fit.
This upgrade use external 12v to not stress the 3dprinter's motherboard, you can swith on and off the light with a switch.
Into the download file I prepared a complete guide step by step and a list of what to buy (very very cheap things).
Rigid temperature test done, no more than 35°C into the led case, you can use safely PLA, PETG is however suggested.
Upgrade you 3d print now!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
