LED Light Base

This is a relatively simple LED box that contains a part of a string light which can be connected to either mains or battery. Important: This base has been designed to fit a full A4/A5/Letter (us) size piece of plexiglass that has a design, the maximum supported width is 3.2mm and minimum supported width of the plexiglass base is 145mm. There are 3 plates to this build: Plate 1: Top and bottom of LED base. Although supports could be used it is easier to leave them out as they are very difficult to remove, printing without supports is no real problem as the holes can be “punched through” with an alan key or M5 bolt. Plate 2: This contains a cover which is designed to go over the light base when assembled so as to hide joins etc. Print with normal (not tree) supports. The supports are easily removed at the end when done. Plate 3: This contains M5 shaped bolts that “could” be used in a pinch, however, these can be very tight and may break rendering the print useless or requiring work to m