LED Ring Lamp

You will need:10 mm wide LED strip, use the highest density LED strip possible, I used 240 leds / meter2x M3 countersunk screw PETG for the body, white TPU/TPE for the diffuserTwo versions:Q version - Side stand, only one color strip possible as the connector wouldn't be able to pass through the small openings. A cap screws on from back, two versions available, one version for bare wires, second version for barrel jack connector.Base stand version - allows any LED strip to be used, this stand includes holes for the power wire and hole for the IR receiver on the side. To prevent using supports I added 0.2 thick bridge layer which you will need to cut off so print at 0.2 mm layer height. M3 screws are optional here, you can use glue insteadPrinting instructionsThe walls of the diffuser are 0.5 mm thick so you will need to use standard 0.4 mm nozzle. As mentioned above, if you print the Base stand version use 0.2 mm layer height.For the body I highly recommend to use PETG as the LED strip