Thingiverse
LED Snowflake
von jmaurio
3
Downloads
0
Likes
0
Makes
This is an LED snowflake ornament. The basic shape is based on https://www.thingiverse.com/thing:34850
Materials:
1 paperclip
Transparent PLA filament
1 CR2032 battery
1 3mm blue LED
How to Assemble:
1. Insert the LED into the hole with the rounded end facing towards the hole at the top of the snowflake. Make sure that the longer lead is facing to the left.
2. Insert the longer lead into the slot on the left and cut the end off so that it does not interfere with the cover.
3. Cut the end of the short lead and insert into the hole in the snowflake.
4. Insert the battery with the flat side facing outward (+).
5. Place the cover on the back (snaps in).
Insert a paperclip into the small hole on the back of the snowflake towards the top to pop off the cover and to remove the battery.
I used 0.2 layer height and 20% infill.
Materials:
1 paperclip
Transparent PLA filament
1 CR2032 battery
1 3mm blue LED
How to Assemble:
1. Insert the LED into the hole with the rounded end facing towards the hole at the top of the snowflake. Make sure that the longer lead is facing to the left.
2. Insert the longer lead into the slot on the left and cut the end off so that it does not interfere with the cover.
3. Cut the end of the short lead and insert into the hole in the snowflake.
4. Insert the battery with the flat side facing outward (+).
5. Place the cover on the back (snaps in).
Insert a paperclip into the small hole on the back of the snowflake towards the top to pop off the cover and to remove the battery.
I used 0.2 layer height and 20% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
