Leg Extension for Ikea Lack table

This is a 6cm leg extension for an IKEA Lack table. I wanted to use a LACK as a frame to an enclosure for my Anycubic Mega Pro 3D printer. The legs on the Lack are about 6cm too short to clear the top of the printer. This simple block has a hole trough the middle to enable you to attach it to the end of the lack leg using a 2.5 inch deck screw. (because that's what I had around the house)
The screw will be inset 1 cm into the bottom of the leg so that it does not stick out and interfere with the table's balance or scratch any surface it sits on.

I printed mine at 0.2mm, 25% infill, no supports, no rafts. That takes 65g of filament per leg, and provides plenty of strength.