Leopard

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmIt is possible to print without masterial system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.The Model is 150x150mm in size. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct.You may print at higher layer heights below the Min Depth of 0.72mm.The Max Depth is 1.9mm and the Actual Depth is 2mm.Filaments Used:PLA ****** + Black Transmission Distance: 0.3PLA Sunlu META Grey Transmission Distance: 3.6PLA BambuLab Basic Orange Transmission Distance: 4.8PLA ****** + White Transmission Distance: 7This print uses 4 unique filamentsSwap Instructions:Start with BlackAt layer #11 (0.96mm) swap to GreyAt layer #14 (1.2mm) swap to OrangeAt layer #16 (1.36mm) swap to White for the rest.