Slicer Discord
Level Sensor – Radar – 3D-Druckmodell von GrabCAD GrabCAD
STEP / IGES, Other

Level Sensor – Radar

1.3k Downloads
108 Likes
0 Makes
Zum Modell
Two models of Radar Level Sensor are presented here. One type is flange mounted and second type is mounted by thread connection. Radar antenna can be different sizes what depends on distance, liquid type…. There is a small antenna on this model, because level distance is shorter than 1000mm. Operating is steadily in range -100°C to 300°C and in low or high pressure. This method can be used in dynamic environment in tanks. Connection: M12 connector and cable connection. Body of sensor is not directly on tank because of temperature influence. If nozzle is higher, it is possible to extension it for a radar antenna. This model can be used indor and outdor.
Kategorie
STEP / IGES, Other
Quelle
GrabCAD
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STEP, STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Dape veröffentlicht auch auf

364 zusätzliche Modelle auf 3 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen