Thingiverse
Levitating Lemur
von igormazurenko
6
Downloads
5
Likes
0
Makes
Hello everyone, here is a model to make "levitating effect" for figure on the pencil top for kids. It' not proper levitation, because one end is held by fishing line.
It was made in scope of the contests that published on Instructables. Detailed description, model for the holder and step by step guide could be found https://www.instructables.com/id/Levitating-Lemur/
Supplies:
• small plastic/rubber figure
• piece of the thin fishing line
• 2 x neodymium magnets I've used cylinder shaped with 5mm in diameter
• tooth pick
• drill with 2 drill bits, one have to be the sane diameter as magnets
• sharp knife
• basic pencil or pen that is suitable for the diameter
• 3D printer
It was made in scope of the contests that published on Instructables. Detailed description, model for the holder and step by step guide could be found https://www.instructables.com/id/Levitating-Lemur/
Supplies:
• small plastic/rubber figure
• piece of the thin fishing line
• 2 x neodymium magnets I've used cylinder shaped with 5mm in diameter
• tooth pick
• drill with 2 drill bits, one have to be the sane diameter as magnets
• sharp knife
• basic pencil or pen that is suitable for the diameter
• 3D printer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
